정밀 알루미늄 6061 선반 터닝 부품

왼쪽 사진은 알루미늄으로 만든 회전부분입니다, 원료는 알루미늄 막대입니다 6061
왼쪽의 작은 부분은 오목한 계단이 있는 작은 알루미늄 부분입니다., 큰 부분은 밀링된 대칭 반대편 알루미늄 회전 부분입니다.. 우리 회사는 알루미늄 스텝 터닝 가공을 잘합니다., 갈기, 태핑 및 테이퍼 각도.
왼쪽 사진의 사양: (작은 알루미늄 터닝 부품)∮6*50 (크기가 큰)∮16*60, 다양한 사양을 생산할 수 있습니다., 자세한 내용은 전화해 주세요.

Boring inner holes and knurled aluminum turning parts
On the left is a knurled aluminum turning part with an inner hole, and an aluminum recessed gasket with anodized surface
About anodizing of aluminum turning parts:
Like: The small aluminum parts on the left are electrolytic anodized, and the transparent film produced by oxidation can be colored into various colored films, which becomes the bright color of the product on the left. 반면에, the oxide film after anodic treatment can improve the wear resistance and rust resistance of the parts, especially the anodic hardening treatment can increase the hardness of the aluminum turned parts. See examples of various colors after anodizing the surface of aluminum turned parts.
The large metal product on the left is processed on an automatic car after using aluminum alloy to straighten the stripes. It can be seen that it has multiple stepped surfaces and multiple inner apertures.

The picture on the left shows the various colors of anodized aluminum turning parts. In addition to these three colors, various colors can be realized.
The three small aluminum parts in the picture and the small aluminum parts in the above picture have the same surface treatment. We put it in different colors for display. Through the comparison in the figure above, you can see its size: ∮6*1 (outer diameter * thickness)
These recessed hole gaskets are mainly used with countersunk screws, which can be used on the holes without countersunk grooves, which are beautiful and practical.

Lathe processing aluminum parts, the surface is treated with dichromate
The gray product on the back left is a hardened aluminum turned processed part
The surface of the aluminum turning workpiece after hard anodizing is sub-gray.

Threaded aluminum turning parts
돌리는 것 외에도, this product also has an inner hexagonal stamping process. As the aluminum itself is softer than other metals such as stainless steel, we used an arm punch (a manual punching device, not a real punch) to punch out the hexagon on the basis of the preset holes.
The external thread of the product can be milled with a sleeve gear seat or a milling gear seat.