Precision Aluminum 6061 ಲೇತ್ ತಿರುಗಿಸುವ ಭಾಗಗಳು

The picture on the left is a turned part made of aluminum, the raw material is aluminum rod 6061
The small part on the left is a small aluminum part with a concave step, and the large part is a milled symmetrical opposite side aluminum turning part. Our company is good at processing aluminum step turning, ಗಿರಣಿ, tapping and taper angle.
ಎಡ ಚಿತ್ರದ ವಿಶೇಷಣಗಳು: (small aluminum turning parts)∮6*50 (ದೊಡ್ಡದು)∮16*60, and we can produce a wide range of specifications, please call for details.

Boring inner holes and knurled aluminum turning parts
On the left is a knurled aluminum turning part with an inner hole, and an aluminum recessed gasket with anodized surface
About anodizing of aluminum turning parts:
Like: The small aluminum parts on the left are electrolytic anodized, and the transparent film produced by oxidation can be colored into various colored films, which becomes the bright color of the product on the left. ಮತ್ತೊಂದೆಡೆ, the oxide film after anodic treatment can improve the wear resistance and rust resistance of the parts, especially the anodic hardening treatment can increase the hardness of the aluminum turned parts. See examples of various colors after anodizing the surface of aluminum turned parts.
The large metal product on the left is processed on an automatic car after using aluminum alloy to straighten the stripes. It can be seen that it has multiple stepped surfaces and multiple inner apertures.

The picture on the left shows the various colors of anodized aluminum turning parts. In addition to these three colors, various colors can be realized.
The three small aluminum parts in the picture and the small aluminum parts in the above picture have the same surface treatment. We put it in different colors for display. Through the comparison in the figure above, you can see its size: ∮6*1 (outer diameter * thickness)
These recessed hole gaskets are mainly used with countersunk screws, which can be used on the holes without countersunk grooves, which are beautiful and practical.

Lathe processing aluminum parts, the surface is treated with dichromate
The gray product on the back left is a hardened aluminum turned processed part
The surface of the aluminum turning workpiece after hard anodizing is sub-gray.

Threaded aluminum turning parts
ತಿರುಗುವುದರ ಜೊತೆಗೆ, this product also has an inner hexagonal stamping process. As the aluminum itself is softer than other metals such as stainless steel, we used an arm punch (a manual punching device, not a real punch) to punch out the hexagon on the basis of the preset holes.
The external thread of the product can be milled with a sleeve gear seat or a milling gear seat.