Path simulation of 5-axis high-speed milling
Because the tool path is more complicated during five-axis high-speed milling, and the tool axis vector changes frequently during the machining process. Especially in high-speed cutting, the tool movement speed is very fast, so it is very necessary to carry out the verification and review of the CNC program before the actual product cnc processing.
Milling can obtain a good curved approximate surface. When using a ball-end tool for three-axis milling, the linear feed motion in the x, y, and z directions can ensure that the tool cuts to any coordinate point on the workpiece, but the direction of the tool axis cannot be changed. The actual cutting speed of the point on the tool axis is zero, and the chip space in the center of the tool is also very small. If these points are involved in cutting, the unfavorable cutting conditions will cause the quality of the machined surface to decrease, the blade wear will increase, and the machining time will be prolonged. So that high-grade tool materials are not fully utilized.
の欠点を克服するために、 3+2 軸加工, 5 軸同時加工の方が良い選択かもしれません, 言うまでもなく、一部の 5 軸工作機械には、金型業界向けに特別に設計された機能もいくつかあります。. 5軸連動加工は直線3軸と回転軸2軸を連携させて同時に動かすことができます。, 3軸の問題をすべて解決し、 3+2 軸加工. ツールは非常に短い場合があります, ビューの重複はありません, 加工領域を取りこぼす可能性が低くなります, 追加のインポートやエクスポートを行わずに処理を継続的に実行できます。 (図を参照 3).
Before adopting 5-axis CNC machining centers, most turbomachinery manufacturers used 3-axis or 4-axis machine tools to process impellers, and most of them used point machining. あれは, every point on the blade surface is processed into a point by the tool tip. When the tool moves along the surface of the blade, it will leave some pits or residual sharp corners, and the height of these pits or sharp corners depends on the programming skills. Point processing is also a feasible method, but this method has some unavoidable disadvantages:
In the CNC machining of the impeller blades, the machining of large impeller blades is the most difficult. Mastering the measures to solve the processing difficulties of large blades has a very positive effect not only on the large blade itself, but also on the impeller moving blades, impeller stationary blades, guide impeller blades and impeller end blades.
CNC machining holes in the solid part of the workpiece with a drill is called drilling. The drilling is rough machining, the achievable dimensional tolerance grade is IT13~IT11, and the surface roughness value is Ra50~12.5μm. Due to the long length of the twist drill, the small core diameter and poor rigidity, as well as the influence of the chisel edge, the drilling has the following technological characteristics:
Inclined CNC parts are often encountered in the production process. Need to punch, boring, and milling shapes on the inclined surface. Or it is necessary to process several inclined surfaces with different directions and different slopes in the same clamping, and each inclined surface has a higher geometric tolerance requirement.
English
العربية
中文(漢字)
Čeština
Dansk
Nederlands
Suomi
Français
Deutsch
Italiano
日本語
ಕನ್ನಡ
한국어
Português
Русский
Slovenčina
Español
Svenska
Türkçe
