machining of revolving parts
09 May
cnc turning technology

Turning and milling combined machining of revolving parts

machining of revolving parts
The development of turning center has a considerable part of rotating parts (someone estimates that it accounts for about 1/2). In addition to turning, operations such as milling, drilling, and tapping are also required. In addition, the processing time for each process of the rotating body is relatively short. Therefore, it is urgent to perform multi-process compound processing on the rotating body under one clamping on a machine tool, and finally a compound turning center was developed in the 1970s.

Continue reading

Turning processing of embossing roller of mask machine
09 May
cnc turning technology, milling technology

Technology of Turning Cast Iron Roller

Flat face mask machine accessories, embossing shaft, press wheel, mask machine roller, roller
The roller is the main part of the rolling mill. It is subject to a certain impact during actual use, and the surface is rubbed by high-speed, high-temperature red steel. The surface is required to have good abrasion resistance, and at the same time, it must have sufficient toughness to prevent it from being broken by impact.

Continue reading

CNC turning of fixed focus lens
09 May
cnc turning technology

cnc turning of fixed focus lens and focus ring

The milling cutter directly mills the groove in layers, but it needs to use the additional fourth axis of the machining center or the C axis function of the turning center to achieve. This article uses a turning center machine tool. The focusing tube was discovered after being processed with a simple fixture. Because the groove is processed through the wall and the groove shape is longer, the axial clamping is only used, and the width of the groove cannot be guaranteed due to the deformation of the clamping during processing.

Continue reading